English
Français
Deutsch
Italiano
Русский
Español
Português
Nederlandse
Ελληνικά
日本語
한국
العربية
हिन्दी
Türkçe
Indonesia
Tiếng Việt
ไทย
বাংলা
Polski
-
Dia1500mm 304 Stainless Steel Wire Mesh 100 For Cylinder Mould Of Paper Machine Cylinder mold Quantity: 1 sets Specification: Φ1500mm×3100mm×3800mm Description: stainless steel plate structure, plate thickness 1.5mm, cast iron spick, thickness 35-40mm.Polish after assembly, balance on installation, ...
-
The paper machine steam dryer rotary joint in different size Scope of application: Maximum speed: ≤100RPM Maximum temperature: ≤220 ℃ Maximum pressure: ≤1.8MPa Applicable medium: saturated steam, superheated steam, superheated water
-
The stainless steel felt sonsor supporter for the felt deviation Wire &felt rectifier also called rectifier, felt deviation controller, pneumatic automatic deviation corrector; Wire &felt deviation corrector; paper machine net blanket corrector; paper machine deviation corrector. It is a device that ...
-
High molecular polyethylene(HDPE)faceboard made for the vacuum suction box / forming board After the slurry is formed on the net and preliminary dewatering, its dryness and tightness gradually increase, and the resistance to dehydration increases. To continue dewatering on the net, a method of high ...
-
stainless steel plate cylinder mold for the wet paper forming The cylinder mold is the main component of the web forming in the cylinder paper machine. stainless steel plates cylinder mold Cast iron spokes, thickness 40mm, spoke pitch 180mm, stainless steel rods, and stainless steel belt width 1.5mm...
-
Craft Paper Making Machine Suction Box FRP Matrix 304 S.S Body Ceramic Faceboard 1. Structure: water leg type vacuum dewatering box (Wet suction box) is a low-vacuum (20-100 mm water column) box. It is fixed on a closed box by several panel strips with sharp front edges. Wide box surface. The panel ...
-
2. Stainless steel dump rejector in the paper pulp cleaning system The rejects separator is an ideal equipment for tailings treatment in waste paper pulping system. Adopting closed operation, no splash of pulp water, good treatment effect, reducing fiber loss, and low slag disposal cost. It is a ...
-
The Whole Stainless Steel Reject Sortor Machine For Second Stage Of Coarse Pulp Cleaning In The Stock Preparation 1. Introduction Features: This machine is mainly used for the treatment of tailings in the screening section of the waste paper system. The incoming pulp concentration is about 1-3%, and ...
You Might Be Interested In
